6002 - xx Network card transmit
failed. 1. Check interrupt type and
number setting.
2. Check media connection at
controller and MAU *.
3. Check media speed (4/16) and
type (UTP/STP **) settings.
4. Check MAU, cabling, or other
network components.
5. Replace controller.
===========================================================================
Error Code Description Recommended Action
===========================================================================
6014 - xx Ethernet configuration The following steps apply to
test failed. 6014 - xx and 6016 - xx error
codes:
6016 - xx Ethernet reset test
failed. 1. Run the ISA setup utility,
reconfigure the failing network
controller, and retest.
2. Ensure that the network
controller is seated properly,
if applicable.
3. Replace the network controller.
---------------------------------------------------------------------------
6028 - xx Ethernet internal The following steps apply to
loopback test failed. 6028 - xx and 6029 - xx error
codes:
6029 - xx Ethernet external
loopback test failed. 1. If using external loopback
plug(s), check that the correct
type of loopback plug is being
used.
2. If using external loopback
plugs, check that loopback plug
is connected to the correct
media connector at the rear of
the computer.
3. If using a live network for
this test, ensure that the
network, concentrators, and
cables are functional.
4. Run the ISA setup utility,
reconfigure the failing network
controller, and retest.
5. Ensure that any jumpers or DIP
switches on the controller
board are set to the correct
positions. (Refer to the
hardware documentation for
more information.)
6. If the network controller is a
stand-alone board, replace the
board.
7. If the network controller is
integrated into the expansion
base system board, replace the
expansion base system board.
8. If using multiple network
controller boards, attempt to
To Next Page
Loading...
Need help?
General