CHAMP-AV8 (VPX6-462) HARDWARE USER’S MANUAL CURTISS-WRIGHT
A-56 PROPRIETARY 826448 VERSION 5 MARCH 2015
RTM JTAG
Connector
The RTM JTAG connector is reserved for Curtiss-Wright use only.
1. Placing an EIA-232 port in loopback does not break the connection to the cable.
Therefore any EIA-232 cables should be removed prior to placing a port in loopback.
2. Installing jumpers in the wrong orientation can potentially damage the board. Be
careful to install jumpers only as shown. See Figure A.21 below.
Figure A.21: Proper Jumper Orientation for RTM P3 Jumpers
NODE A0_TX
NODE A1_TX
NODE B0_TX
NODE B1_TX
NODE A0_RX
NODE A1_RX
NODE B0_RX
NODE B1_RX
X
CORRECT
INCORRECT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...