CHAMP-AV8 (VPX6-462) HARDWARE USER’S MANUAL CURTISS-WRIGHT
2-6 PROPRIETARY 826448 VERSION 5 MARCH 2015
CABLE REQUIREMENTS
A Front Panel interface cable is available to support the CHAMP-AV8. This cable is identified as:
• CBL-462-FPL-000 (CHAMP-AV8 Standard Front Panel Cable Assembly - see Figure 2.1)
CBL-462-FPL-000
(903075-000)
Figure 2.1 shows a cable drawing of the CHAMP-AV8 Standard Front Panel Cable Assembly
(CBL-462-FPL-000). The cable assembly provides access to the following CHAMP-AV8 signals:
USB A (J1); RS-232 Port A0 (J2); RS-232 Port B0 (J3); Ethernet Port 0 (J4); Ethernet Port 1
(J5); Reset Switch (SW1).
Figure 2.1: CBL-462-FPL-000 (CHAMP-AV8 Standard Front Panel Cable
Assembly)
The CHAMP-AV8 front panel cable is different than that used on the CHAMP-AV6, even
though the physical front panel connector is the same. To use the CHAMP-AV8 front panel,
the user must employ CBL-462-FPL-000.
J1
J2
J3
J4
J5
SW1 RESET
36" +/- 2"
Add heatshrink as
Required to secure adapter
Add 903075-000
assembly number label
and associated revision.
Located anywhere on this
branch.
Add 2" transparent
heatshrink sleave (0.5"
diameter) for CWC lable
(part # 172249-503)
application under the
heatshrink. Leave
heatshrink loose, ie. do not
heat.
P1
18" +/- 1"
POS.1POS.14
POS.13POS.26
Add label near connector
with reference designator
and function per parts list
table comments.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...