Datalogic QuickScan Lite QW2100 User Manual

Getting Started
8 QuickScan
TM
Lite QW2100
Hands Free Stand — continued
The holder cup can be positioned in any of the three angles shown in Figure 4. Grasp
the holder cup as indicated and rotate to the desired position.
Refer to Scan Mode on page 30 for information about programming the reader for use
with the stand.
Figure 4. Adjusting the Stand
This accessory can also be used as a holder to mount the reader on a wall or other vertical
position as shown in Figure 5.
Figure 5. Using the Wall Holder
Programming
The reader is typically factory-configured with a set of default features standard to the
interface type you ordered. After scanning the interface bar code from the
Interfaces sec-
tion, you can select other options and customize your reader through use of the instruc-
tions and programming bar codes available in the corresponding features section for your
interface and also the
Data Editing and Symbologies chapters of this manual.

Datalogic QuickScan Lite QW2100 Specifications

General

Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	Laser
Read rate (max)	400 reads/s
Yaw reading angle	-70 - 70 °
Tilt reading angle	-45 - 45 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	EAN 5, EAN-13, EAN-8, GS1-128 (UCC/EAN-128)
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Input voltage	5 V
Power consumption	340 mA
Power source type	DC
Product color	Black
Housing material	-
International Protection (IP) code	IP42
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	65 mm
Width	170 mm
Height	70 mm
Weight	119 g