Datalogic QuickScan Lite QW2100

RS-232/USB-Com Interfaces
46 QuickScan
TM
Lite QW2100
ENTER/EXIT PROGRAMMING MODE
ACK NAK Options
This enables/disables the ability of the reader to support the RS-232 ACK/NAK protocol.
When configured, the reader and/or host sends an “ACK” when it receives data properly, and
sends “NAK” when the data is in error.
Options are:
•Disable
• Enable for label transmission — The reader expects an ACK/NAK response from the host
when a label is sent.
• Enable for host-command acknowledge — The reader will respond with ACK/NAK
when the host sends a command.
• Enable for label transmission and host-command acknowledge
$CR2AE00
ACK/NAK Protocol = Disable ACK/NAK
$CR2AE01

ACK/NAK Protocol = Enable for label transmission
$CR2AE02

ACK/NAK Protocol = Enable for host-command
acknowledge
$CR2AE03

ACK/NAK Protocol = Enable for label transmission and host-com-
mand acknowledge
DEFAULT