Sleep Mode Timeout
Product Reference Guide 21
ENTER/EXIT PROGRAMMING MODE
Sleep Mode Timeout
Specifies the timeout value for the reader to enter Sleep Mode (a very low power consumption
state).
NOTE
RS-232 interface ONLY.
A reader having a Scan Mode setting of Object Sense, Stand Mode,
Flashing, or Always On will not enter Sleep Mode. (The reader is
always internally active when in these modes.)
$CSLTO00
Sleep Mode Timeout = Disabled
$CSLTO1E
Sleep Mode Timeout = 30 Seconds
$CSLTO3C
Sleep Mode Timeout = 1 Minute (60 Seconds)
$CSLTO5A
Sleep Mode Timeout = 1 Minute 30 Seconds (90 Seconds)
$CSLTO78
Sleep Mode Timeout = 2 Minutes (120 Seconds)
To Next Page
Loading...
