Datalogic QuickScan Lite QW2100 User Manual

Product Reference Guide 275
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of Table 3.
The settings in this table are as applied to a standard RS-232 interface. See Table 4 for a
listing of default exceptions to this list as appled to other interface types. Page references
are also provided for feature descriptions and programming bar codes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 3. Standard Defaults
Parameter Default Your Setting Page Number
General Features
Host Commands — Obey/Ignore
Obey
15
USB Suspend Mode
Disable
16
Double Read Timeout
0.4 Second
17
Label Gone Timeout
160 ms
19
Power Save Mode
Enabled
20
Sleep Mode Timeout
Disabled
21
Power On Alert
4 Beeps
22
Good Read: When to Indicate
After Decode
23
Good Read Beep Type
Mono
24
Good Read Beep Frequency
Medium
25
Good Read Beep Length
80 ms
25
Illumination Control
Illumination Off
during beep
27
Good Read Beep Volume
High
28
Good Read LED Duration
LED on until
next trigger pull
29
Scan Mode
Trigger Single
30
Stand Mode Triggered Timeout
0.5 Seconds
31

Datalogic QuickScan Lite QW2100 Specifications

General

Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	Laser
Read rate (max)	400 reads/s
Yaw reading angle	-70 - 70 °
Tilt reading angle	-45 - 45 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	EAN 5, EAN-13, EAN-8, GS1-128 (UCC/EAN-128)
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Input voltage	5 V
Power consumption	340 mA
Power source type	DC
Product color	Black
Housing material	-
International Protection (IP) code	IP42
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	65 mm
Width	170 mm
Height	70 mm
Weight	119 g