Datalogic QuickScan Lite QW2100 User Manual

Label ID
Product Reference Guide 71
ENTER/EXIT PROGRAMMING MODE
Label ID: Set Individually Per Symbology
This feature configures a Label ID individually for a single symbology.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or suffix for a given sym-
bology type.
NOTE
This setting requires the scanning of bar codes from multiple sec-
tions. See
Label ID: Set Individually Per Symbology on
page 264
for more detailed programming instructions.
$CIDCO00
Label ID Transmission = Disable
$CIDCO01

Label ID Transmission = Enable as Prefix
$CIDCO02

Label ID Transmission = Enable as Suffix
~
CANCEL
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
DEFAULT

Datalogic QuickScan Lite QW2100 Specifications

General

Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	Laser
Read rate (max)	400 reads/s
Yaw reading angle	-70 - 70 °
Tilt reading angle	-45 - 45 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	EAN 5, EAN-13, EAN-8, GS1-128 (UCC/EAN-128)
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Input voltage	5 V
Power consumption	340 mA
Power source type	DC
Product color	Black
Housing material	-
International Protection (IP) code	IP42
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	65 mm
Width	170 mm
Height	70 mm
Weight	119 g