Getting Started
10 QuickScan
TM
Lite QW2100
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard in-
terfaces by scanning the following label.
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved
in the reader, scan the Restore Custom Default Configuration bar code below. This will
restore the custom configuration for the currently active interface.
Resetting the Product Configuration to Defaults — cont.
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can
scan the Restore USA Factory Configuration bar code or the Restore EU Factory Con-
figuration
bar code below. Both labels restore the reader configuration to the factory set-
tings including the interface type. The USA label restores Label IDs to those historically
used in the USA. The EU label restores Label IDs to those historically used in Europe.
The Label ID sets for USA and EU are shown in the Label ID section of this manual.
The programming section lists the factory default settings for each of the menu com-
mands (indicated by shaded blocks and bold text) on the following pages.
Transmit Software Version
NOTE
Custom defaults are based on the interface type. Configure the
reader for the correct interface before scanning this label.
Restore Custom Default Configuration
Restore USA Factory Configuration
Restore EU Factory Configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
