Deif AGC 100 - Page 113

Description Comments
Product
type
Select AGC.
Plant
type
Select between
● Single DG
● Standard
Use "single DG" if power management is not present (or if single
functionality is needed for an AGC 14x).
Use "standard" if a power management application is needed,
where more than one AGC is present.
Configu-
ration
selection
The AGC is able to in-
clude four applications.
One of these can be ac-
tive.
Write a proper name of
your application.
Click "Yes" in the pop-up window to set the application to active
when downloading it to the AGC.
It is possible to see which application is active when the USW is
connected to the AGC. The green arrow in the picture below shows
which application is active.
Bus tie
options
Select "Wrap busbar" if
the BTBs are connected
in a ring.
Power
manage-
ment
CAN
Primary CAN
Secondary CAN
CAN bus off: Disable
CAN bus A and B
These settings do not impact whether CAN terminal A or B is used.
This must be set up in menu 7840.
Applica-
tion em-
ulation
Used to enable emula-
tion and to choose
whether breaker and
engine command is ac-
tive or not during emula-
tion.
This selection is only available if the option I1 (emulation) is active
in the unit.
Now the application can be designed using the area configuration control panel.
AGC 100 Designer's Reference Handbook
4189340766 UK
Power management (AGC 14x only)
DEIF A/S Page 113 of 152