A priority routine ensures that the running hours of the available fans are evened out and the priority shifts
between them.
The functionality behind the temperature-dependent start/stop is that the AGC measures a temperature, e.g.
cooling water temperature, and based on this temperature it switches on and off relays that must be used for
engaging the fan(s) itself.
The fan control function is active as long as running feedback is detected.
6.34.1 Fan parameters
Each fan has a group of parameters that defines their scheme of operation. It is recommended to use the PC
utility SW for the setup, because then it is possible to see all parameters. The setup of the fan control is done
in the menus 6561-6620 and by using M-Logic in the PC utility SW.
Parameters:
AGC 100 Designer's Reference Handbook
4189340766 UK
Additional functions
DEIF A/S Page 97 of 152
To Next Page
Loading...
