GB1 ON
t
1
t
2
R1 R2
200
1000
800
600
400
P
AVAIL
kW
GB2 ON
To connect the load groups, individual relays can be selected on each AGC or on one of the AGC units only.
8.4.17 CAN flags
16 CAN flags can be accessed in M-Logic. They can be used in the same way as digital inputs. CAN flags
can be set active when a CAN command is sent from one unit to another. The benefit is that no wire is nee-
ded, as the CAN flags are activated via the CANbus.
AGC 100 Designer's Reference Handbook
4189340766 UK
Power management (AGC 14x only)
DEIF A/S Page 134 of 152
To Next Page
Loading...
