The functions marked with clear text in the screenshots below can be accessed through the quick setup
menu.
8.4 Functional description
8.4.1 Command unit
The power management system is a multi-master system. In a multi-master system, the available generator
units automatically perform the power management control. This means that the system never depends on
only one master unit.
If for instance one unit ID is disabled, and this was the command unit, then the next available unit will take
over the command functions.
The above also applies to the AGC mains units – in that case the command unit is called Mains Command
Unit (MCU).
The command unit cannot be selected by the operator. It is automatically selected when a power manage-
ment setting is accessed.
AGC 100 Designer's Reference Handbook
4189340766 UK
Power management (AGC 14x only)
DEIF A/S Page 123 of 152
To Next Page
Loading...
