Deif AGC 100 - Inhibit; Running Signal; Idle Speed Flowcharts

Start Stop
RPM
300
1500
t
The oil pressure alarm (RMI oil) will be enabled during idle run if set to "ON".
6.11.4 Inhibit
The alarms that are deactivated by the inhibit function are inhibited in the usual manner, except for the oil
pressure alarms; RMI oil 6,7 and 8 which are active during "idle run" as well.
6.11.5 Running signal
The running feedback must be activated when the genset is running in idle mode.
6.11.6 Idle speed flowcharts
The flowcharts illustrate the starting and stopping of the genset by use of the inputs "temp control" and "low
speed".
AGC 100 Designer's Reference Handbook
4189340766 UK
Additional functions
DEIF A/S Page 63 of 152