The following start/stop curve will be generated if a bow setting is used:
6.34.4 Fan output
At parameter 6581 to 6584, the output relays for fans A to D are selected. The purpose of these relays is to
issue a signal to the fan starter cabinet. The relay must be energised for the fan to run.
6.34.5 Fan start delay
If two or more fans are requested to be started at the same time, it is possible to add a start delay between
each fan start. The reason for this is to limit the peak start current, so all fans will not contribute with a start
current at the same time. This delay is adjusted in the menu 6586.
AGC 100 Designer's Reference Handbook
4189340766 UK
Additional functions
DEIF A/S Page 99 of 152
To Next Page
Loading...
