Deif AGC 100 - Breaker Feedbacks; Mains Breaker (MB) Feedback; Tie Breaker (TB)

For AGC 100, there are two CANbus outputs, CAN A + B.
8.7 Breaker feedbacks
8.7.1 Mains breaker (MB) feedback
The required feedback from the breaker depends on which type of breaker is used.
MB present: See "Additional functions" chapter about breaker feedback in this document
MB not present: Selected in the application configuration (USW).
When no MB is represented, the MB open and close relays together with the inputs for MB
open and close feedbacks will be configurable.
8.7.2 Tie breaker (TB)
The required feedback from the breaker depends on which type of breaker is used.
TB present: See "Additional functions" chapter about breaker feedback in this document.
TB not present: Selected in the application configuration (USW)
When no TB is represented, the TB open and close relays together with the inputs for TB open
and close feedbacks will be configurable.
AGC 100 Designer's Reference Handbook
4189340766 UK
Power management (AGC 14x only)
DEIF A/S Page 140 of 152