The M-Logic is part of the PC utility software, and as such, it can only be configured in the PC
utility software and not via the display. Please see the M-Logic manual which is available at .
The main purpose of M-Logic is to give the operator/designer more flexible possibilities of operating the gen-
erator control system.
Please refer to the "Help" function in the PC utility software for a full description of this config-
uration tool.
6.29 Buzzer
6.29.1 Buzzer
The AGC 100 has a built-in buzzer. The buzzer is configured in M-Logic. This means that if the buzzer is
going to be used as a horn annunciator, the input must be set to "Horn" and the output must be set to "Buz-
zer". The buzzer will act concurrently to the horn output timer. If the delay timer in M-Logic is used, the buzzer
will be active after this time delay.
If an AOP-2 is connected, the buzzer in the AOP-2 must be configured under the AOP-2 setup.
But the configuration of the AOP-2 buzzer is similar to the description above.
6.30 GSM communication
6.30.1 GSM and modem communication
GSM communication can be used for two purposes:
1. Sending SMS alarm messages to up to 5 different mobile phones. The messages will be clear text, repre-
senting the alarm in question (e.g. “Overspeed”) and an ID. The ID represents the total numbers of sent
SMS.
2. Communicate with the PC utility software.
AGC 100 Designer's Reference Handbook
4189340766 UK
Additional functions
DEIF A/S Page 92 of 152
To Next Page
Loading...
