t
t
RUN
Run. feedback
Alarms active
The timer is ignored if digital running feedback is used.
6.7 Access lock
The purpose of access lock is to deny the operator the possibility to configure the unit parameters and
change the running modes from the display and digital inputs. When activated the display will read "Access
lock" when pushing the display buttons affected by the access lock, please see the table below.
The input to be used for the access lock function is defined in the PC utility software (USW).
Access lock will typically be activated from a key switch installed behind the door of the switchboard cabinet.
AGC 100 Designer's Reference Handbook
4189340766 UK
Additional functions
DEIF A/S Page 56 of 152
To Next Page
Loading...
