Read this first
Regulatory information
v The library must be installed in a restricted area.
v Only personnel with technical and product safety training should have access to the library.
v To comply with the regulations and standards, the library must be properly installed in an office or
industrial environment with shielded cables and adequate grounding of SAS interface and input
power.
v Models: 3555-L3A, 3555-E3A
Table 1. Regulatory marks
The CE mark is a mandatory conformity mark on many products that are
placed on the single market in the European Economic Area (EEA). The
CE marking certifies that a product meets EU consumer safety, health, or
environmental requirements.
CSA C22-2 No.60950-1 - Electrical safety - UL 60950-1 68475
Minimum firmware levels for common library features
Table 2. Minimum firmware levels for common library features
Feature Minimum Firmware Levels Required
LTO8 (HH/FH) Tape Drives Library Firmware must be at 1.1.1.0 or greater to support
the LTO8 tape drives. Ensure that any host applications
and device drivers are at the minimum level that is
required to support LTO8 tape drives.
LTO6 (HH/FH) and LTO7 (HH/FH) Tape Drives Library Firmware must be at 1.1.0.1-A00 or greater to
support the LTO6 and LTO7 tape drives. Ensure that any
host applications and device drivers are at the minimum
level that is required to support LTO6 and LTO7 tape
drives.
Library Managed Encryption Library Firmware must be at 1.1.1.0-A00 or greater to
support the Library Managed Encryption feature. Ensure
that any key manager applications are at the minimum
level that is required to support the 3U library.
Path Failover (Control Path and Data Path) Library Firmware must be at 1.1.1.0-A00 or greater to
support the Path Failover feature. Ensure that any device
drivers are at the minimum level that is required to
support the 3U library.
xi
To Next Page
Loading...
Need help?
General
