Dell EMC ML3 User Manual

Tables
1. Regulatory marks .......... xi
2. Minimum firmware levels for common library
features .............. xi
3. Module designations .......... 1
4. Minimum and maximum storage configurations 2
5. Library configurations ......... 3
6. Front panel descriptions......... 7
7. Rear panel descriptions ......... 8
8. Physical numbering of storage slots - bottom
module .............. 10
9. Power supply LEDs .......... 11
10. Supported tape drives ......... 12
11. Drive sled indicators ......... 13
12. Half-height SAS dual port........ 14
13. Half-height FC single port ....... 14
14. Full-height FC dual port ........ 15
15. Differences between CPF and DPF ..... 18
16. Location requirements ......... 23
17. Physical specifications ......... 24
18. Electrical specifications......... 24
19. Equipment environmental specifications 24
20. Gas and particulate exposure ...... 25
21. Power cords ............ 26
22. Installation Precautions ........ 33
23. Full-height FC dual port ........ 50
24. Half-height FC single port ....... 50
25. Half-height SAS dual port........ 51
26. Main screen elements ......... 60
27. Navigation Dock ........... 61
28. Status icons ............ 61
29. Operator Panel menu tree........ 62
30. Front panel LEDs .......... 63
31. Locating Management functions ..... 63
32. Default settings ........... 66
33. Magazine state ........... 70
34. Resolving errors ........... 73
35. Main error events .......... 79
36. Warning events ........... 86
37. Configuration Change events ...... 93
38. Informational Events ......... 94
39. Error codes on the single-character display 101
40. Meaning of Status light and single-character
display (SCD) ........... 102
41. Internal view description ....... 105
42. Pinch hazard............ 106
43. Power supply components ....... 115
44. Controller card components....... 118
45. Cartridge data capacity and recording formats 143
46. Nominal cartridge life: Load/unload cycles 144
47. Data cartridge compatibility with LTO tape
drive .............. 144
48. Cartridges and VOLSERs compatible with the
LTO Tape Drives .......... 146
49. Location of the write-protect switch .... 148
50. Environment for operating, storing, and
shipping the LTO Ultrium Tape Cartridge .. 151
ix

Dell EMC ML3 Specifications

General

Number of Drives	1
Category	Tape Library
Drive Technology	LTO
Humidity	20% to 80% (non-condensing)
Drive Type	LTO Ultrium
Maximum Capacity	15 TB (compressed)
Interface	6Gb/s SAS
Max Data Transfer Rate	up to 750 MB/s (with compression)
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)