Table 37. Configuration Change events (continued)
Event Code Message Text and Description
8061 New Base Library Controller detected.
8062 Auto calibration successfully finished.
8064 Password rules configuration changed.
8065 User was added.
8066 User was deleted.
8069 User password changed.
8072 Kerberos Realm was added.
8073 Kerberos Realm was modified.
8074 Kerberos Realm was deleted.
8075 Kerberos User was added.
8076 Kerberos User was modified.
8077 Kerberos User was deleted.
Informational events
Table 38. Informational Events
Event Code Message Text and Description
9000 A tape alert flag was reported by a drive.
9001 A drive is present but currently disabled.
9002 The library was powered on.
9003 Move Medium command was run.
9004 Inventory scan was completed.
9005 The library was powered down from Front Panel.
9006 The network interface was turned on.
9007 The network interface was turned off.
9008 The System Time was synchronized with an NTP server.
9009 A magazine was unlocked and opened.
9010 A magazine was closed and locked.
9011 An I/O station was unlocked and opened.
9012 An I/O station was closed and locked.
9013 A user logged in at the Management GUI.
9014 A user logged out at the Management GUI.
9015 A user logged in at the Operator Panel interface.
9016 A user logged out at the Operator Panel interface.
9024 Drive support ticket created.
9025 Library test started.
9026 Library test successfully finished.
9027 Library test was stopped by user.
9028 Configuration back up to chassis was successful.
9029 Configuration restore from chassis was successful.
9031 Library health Status was changed to status "OK”.
94 Dell EMC ML3 Tape Library: User's Guide
To Next Page
Loading...
Need help?
General
