Dell EMC ML3 User Manual

The library assigns each tape drive a SCSI element address that consists of a value that defines a logical
location in the library to the SCSI interface. It is assigned and used by the application when the host
server processes SCSI commands. The SCSI element address for a drive is unique to the location of the
drive. It does not vary based on other drives in the library. See “Library partitioning” on page 57.
Supported tape cartridges
Within the library, the supported LTO tape drives use the following cartridge types:
v LTO8 Data Cartridge
v LTO8 WORM Data Cartridge
v LTO7 Data Cartridge
v LTO7 WORM Data Cartridge
v LTO6 Data Cartridge
v LTO6 WORM Data Cartridge
v LTO5 Data Cartridge
v LTO5 WORM Data Cartridge
v LTO4 Data Cartridge
v LTO4 WORM Data Cartridge
v Universal LTO Cleaning Cartridge
Figure 22. Physical numbering of drives
16 Dell EMC ML3 Tape Library: User's Guide

Dell EMC ML3 Specifications

General

Number of Drives	1
Category	Tape Library
Drive Technology	LTO
Humidity	20% to 80% (non-condensing)
Drive Type	LTO Ultrium
Maximum Capacity	15 TB (compressed)
Interface	6Gb/s SAS
Max Data Transfer Rate	up to 750 MB/s (with compression)
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)