Dell EMC ML3 - Open I;O Station Seen from the Left

Important: The lowest I/O slot of the lowest module in a library is inaccessible to the accessor, so the
I/O Station of the lowest module has four slots instead of 5.
Bulk loading magazines
1. Unlock the magazine by pressing the magazine button for more than 3 seconds, wait for the button to
flash fast and then pull out the magazine.
a. From the Operator Panel or Management GUI, select the module and then select Open Magazine.
You can also press the release button on the front panel of the module to release the magazine.
b. Wait until the magazine is unlocked, and then pull out the magazine.
Note: Wait for the Operator Panel/Management GUI message to say that the magazine is
unlocked before the magazine is pulled out.
Figure 53. Open I/O station seen from the left
54 Dell EMC ML3 Tape Library: User's Guide