Name: Dell EMC ML3
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

v An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the

system or the devices that attach to the system. It is the responsibility of the customer to ensure that

the outlet is correctly wired and grounded to prevent an electrical shock. (R001 part 1 of 2)

Caution

v Do not install a unit in a rack where the internal rack ambient temperatures might exceed the

manufacturer's recommended ambient temperature for all your rack-mounted devices.

v Do not install a unit in a rack where the air flow is compromised. Ensure that air flow is not blocked

or reduced on any side, front, or back of a unit that is used for air flow through the unit.

v Consideration must be given to the connection of the equipment to the supply circuit so that

overloading of the circuits does not compromise the supply wiring or overcurrent protection. To

provide the correct power connection to a rack, refer to the rating labels on the equipment in the rack

to determine the total power requirement of the supply circuit.

v (For sliding drawers) Do not pull out or install any drawer or feature if the rack stabilizer brackets are

not attached to the rack. Do not pull out more than one drawer at a time. The rack might become

unstable if you pull out more than one drawer at a time.

v (For fixed drawers) This drawer is a fixed drawer and must not be moved for servicing unless

specified by the manufacturer. Attempting to move the drawer partially or out of the rack might cause

the rack to become unstable or cause the drawer to fall out of the rack. (R001 part 2 of 2)

Caution

Removing components from the upper positions in the rack cabinet improves rack stability during

relocation. Follow these general guidelines whenever you relocate a populated rack cabinet within a room

or building:

v Reduce the weight of the rack cabinet by removing equipment, starting at the top of the rack cabinet.

When possible, restore the rack cabinet to the configuration of the rack cabinet as you received it. If

this configuration is not known, you must do the following:

– Remove all devices in the 32U position (compliance ID RACK-001) or 22U (compliance ID RR001)

and above.

– Ensure that the heaviest devices are installed in the bottom of the rack cabinet.

xviii Dell EMC ML3 Tape Library: User's Guide

Questions and Answers:

Need help?

Do you have a question about the Dell EMC ML3 and is the answer not in the manual?

Dell EMC ML3 Specifications

General