Dell Networking N4000 Series - Page 514

514 Configuring Port and System Security
2 Click Show All to display the Dot1x Authentication Table page.
3 In the Ports list, select the check box in the Edit column for the port to
configure.
4 Select the desired settings to change for all ports that are selected for
editing.
Figure 19-3. Configure Dot1x Settings
5 Click Apply .
To reauthenticate a port:
1
Open the Dot1x Authentication page.
2 Click Show All .
The
Dot1x Authentication Tab le displays.
3 Check Edit to select the Unit/Port to re-authenticate.
4 Check Reauthenticate Now .
5 Click Apply .
The authentication process is restarted on the specified port.
To reauthenticate multiple ports:
1
Open the Dot1x Authentication page.
2 Click Show All .
The
Dot1x Authentication Tab le displays.
3 Check Edit to select the Units/Ports to re-authenticate.
4 To re-authenticate on a periodic basis, set Periodic Re-Authentication to
Enable, and specify a
Re-Authentication Period for all desired ports.