45
8.2.5.4 Menu Screwdriving Sequence
8.2.5.4.1 Modify
Use the menu item “Screwdriving Sequence Modify” to adjust the parameters of the in-
dividual screwdriving program. At first, the system asks for the program number to be in-
put. Thereafter, the cursor allows to select between the individual parameters within one
program.
Use the function-key to switch from one to the next program step.
To input a numerical value, use the ENTER-key, then input the value and again press the
ENTER-key. Only numbers, which are within an allowable range of the driver, are ac-
cepted.
To change the selection values, use the ENTER-key, then use the cursor key to select the
required value and again use the ENTER-key to confirm the change.
Use the ESC-key to interrupt an input; the previous valid values remain. Again, use the
ESC-key to exit the menu.
Now, use the two function keys to save or not save the changes!
left function key: the changes will be saved, the values will be reconfirmed and if nec-
essary, the system will return to the menu to adjust the parameter
right function key: all changes will be disregarded, the program remains unchanged.
8.2.5.4.2 Default Programs
Use the menu item “Default Programs” to generate the programs 1 and 16 as standard
programs.
The programs will be generated as follows:
Program 1: one-step tightening to torque with driver-dependent standard values
Program 16: one-step loosening to angle with driver-dependent standard values.
ATTENTION
Generating default programs will overwrite programs 1 and 16.
All other programs will be invalid!
To Next Page
Loading...
