53
If you enter a valid password then all pages are accessible. Otherwise, the pages on which
changes can be made are hidden.
8.3.4.2 System Info Tool Data
This page displays the most-important data of the connected Screwdriver. These data
cannot be changed on this page.
Figure 16: Tool data
The following data is displayed:
• Software version: version of the screwdriver logic
• Screwdriver type: name of the screwdriver type
• Serial number: individual serial number of the screwdriver
• Torque settings: screwdriver specific value to adapt the torque calculation to special
cases
• Minimum torque: smallest possible torque
• Maximum torque: largest possible torque
• Minimum rotation speed: smallest possible rotation speed
• Maximum rotation speed: largest possible rotation speed
• Maximum torque hold time: longest possible time that the screwdriver can maintain a
constant torque
• Number of cycles: number of screwdriving procedures of the screwdriver
• Number of cycles at last maintenance: number of screwdriving procedures of the
screwdriver at the time of the last maintenance
• Maintenance interval: interval describes the number of screwdriving procedures until
the next maintenance is due
• Next maintenance: the next maintenance of the screwdriver is due when the speci-
fied number of screwdriving procedures has been reached
To Next Page
Loading...
