Deprag AST11-1 - Setup  Time; Setup  F-Control; Setup  Password; Figure 26: Date; Time

60
8.3.4.9 Setup  Time
Here, you can enter the date and time of the sequence controller AST11.
Figure 26: Date / Time
8.3.4.10 Setup  F-Control
If you use the F-control function, use this area to do the appropriate adjustments.
Figure 27: Setup F-Control
More information on the F-Control function you find in chapter 9 F-Function.
8.3.4.11 Setup  Password
On this page you can set the password for the access to the sequence controller AST11.
Figure 28: Change password
The password is only valid for changes to the settings of the sequence controller AST11,
not for the complete access.