B-2
95-8533
18.2
Class I Division 1 Groups B, C & D, T6, TYPE 4X:
EQ3770EIO Series
Class I Division 2 Groups A, B, C & D T3A
Class I Zone 2, IIC T3, TYPE 4X:
EQ3900N Series
Ordinary Locations :
EQ3900G Series
EQP System Gas Detector / Sensors Class 4828-01 & 4828-02 (See individual Certicates)
PIRECL® Series, PIR9400 Series, PIRDUCT Series, OPECL Series, LS2000 Series , GT3000 Series
, NTM Series , C7064E Series, CGS Series (Note: EQ22abDCUEX and UD10xxxxxC are required
for use with CGS catalytic sensor.), PIRTB Series, STB Series, UD10 Series.
EQP System Flame Detectors Equipment Class 4818 04 (See individual Certicates)
X3301 Series, X3302 Series, X2200 Series, X9800 Series, X5200 Series
Notes:
Note 1: Any CSA certified Combustible or Toxic Gas Sensor / detector with 4-20mA
(industry standard) output may be used with EQ3710AIM, UD10 and EQ22abDCU.
Note 2: Detector Electronics combustible gas detection K factors are not CSA verified.
Note 3: CSA Certification of the 4-20mA input does not include or imply approval of the gas
detection apparatus such as sensors, transmitters, or devices connected to the system. In order
to maintain CSA Certification of the system, all 4-20mA gas detection instruments connected to the
input must also be CSA Certified.
Note 4: CSA Certification allows the presence and operation of serial/Ethernet communications
software in the Controller (Modbus TCP/IP, Allen Bradley protocols, etc.); however, the
communications functions are not included in the Certification.
To Next Page
Loading...
