Develop ineo 163 - Changing the Print Density (PRINT DENSITY Parameter)

7
Utility mode/Copy mode parameters
7-14 ineo 163/213
Changing the print density ("PRINT DENSITY" parameter)
1 Display the "MACHINE SETTING" menu.
– Refer to "Displaying the "MACHINE SETTING" menu" on page 7-7.
2 Press the [+] or [,] key until "PRINT DENSITY" is selected, and then
press the [OK] key.
3 Press the [*] or [)] key until the desired density level is selected, and
then press the [OK] key.
The "MACHINE SETTING" menu appears again.
UTILITY MODE
PAPER SOURCE SETUP
MACHINE SETTING
CUSTOM SIZE MEMORY
MACHINE SETTING
DENSITY(BOOK)
DENSITY(ADF)
PRINT DENSITY
PRINT DENSITY
OK