Develop ineo 163 - Output Priority; Selecting the Default Finishing Setting (OUTPUT PRIORITY Parameter)

Utility mode/Copy mode parameters
7
ineo 163/213 7-73
Selecting the default Finishing setting ("OUTPUT PRIORITY" parameter)
1 Display the "COPY SETTING 2" menu.
– Refer to "Displaying the "COPY SETTING 2" menu" on page 7-71.
2 Press the [+] or [,] key until "OUTPUT PRIORITY" is selected, and then
press the [OK] key.
3 Press the [+] or [,] key until "NON-SORT", "SORT" or "GROUP" is
selected, and then press the [OK] key.
The "COPY SETTING 2" menu appears again.
UTILITY MODE
RETURN
COPY SETTING 2
COPY SETTING 2
OUTPUT PRIORITY
COPY PRIORITY
4IN1 COPY ORDER
OUTPUT PRIORITY
SORT
NON-SORT
GROUP