Develop ineo 163 - Changing the Image Quality Level When the Document Feeder Is Used (DENSITY (ADF) Parameter)

7
Utility mode/Copy mode parameters
7-12 ineo 163/213
Changing the image quality level when the document feeder is used
("DENSITY (ADF)" parameter)
1 Display the "MACHINE SETTING" menu.
– Refer to "Displaying the "MACHINE SETTING" menu" on page 7-7.
2 Press the [+] or [,] key until "DENSITY (ADF)" is selected, and then
press the [OK] key.
3 Press the [+] or [,] key until "MODE1" or "MODE2" is selected, and
then press the [OK] key.
The "MACHINE SETTING" menu appears again.
UTILITY MODE
PAPER SOURCE SETUP
MACHINE SETTING
CUSTOM SIZE MEMORY
MACHINE SETTING
DENSITY(BOOK)
DENSITY(ADF)
PRINT DENSITY
DENSITY(ADF)
MODE2
MODE1