Status, Error, and Service Messages 10-41
COMMUNICATION ERROR
USB Memory
While data was
being sent in Scan
mode, the connec-
tion to the USB
memory device was
interrupted.
Check the connection
to the USB memory
device, and then try
sending the data
again.
COMMUNICATION ERROR
xxx Server
While data was
being sent in Scan
mode, the connec-
tion to the server
was interrupted.
Check the settings in
the [NETWORK SET-
TING] menu, and then
try sending the data
again.
DISCONNECT
USB Memory
The connection to
the USB memory
device was inter-
rupted.
Check the connection
to the USB memory
device, and then try
sending the data
again.
DISCONNECT
xxx Server
The connection to
the server was
interrupted.
Check the settings in
the [NETWORK SET-
TING] menu, and then
try connecting again.
Fuser Unit Life The time to replace
the fuser unit has
been reached.
Replace the fuser unit.
I-UNIT END
REPLACE x
The time to replace
the indicated imag-
ing unit has been
reached.
Replace the indicated
imaging unit.
I-Unit End x The time to replace
the indicated imag-
ing unit has been
reached.
Replace the indicated
imaging unit.
I-Unit Life (x) The time to replace
the indicated imag-
ing unit has been
reached.
Replace the indicated
imaging unit.
I-Unit Low x The indicated imag-
ing unit is low and
should be replaced
within 200 pages at
5% coverage of
Letter/A4 paper.
Prepare the indicated
imaging unit.
This message... means... Do this...
To Next Page
Loading...
