Configuration Menu Overview 2-37
[REMOTE MONITOR] Settings [OFF] / [ON]
Select whether or not setting
remote monitor.
If [ON] is selected, technical sup-
port can access the menu mode.
If [OFF] is selected, technical sup-
port cannot access the menu
mode.
d
This setting is for technical
support uses. Change the
setting only when it is
necessary.
d
If this machine is connected
with a USB cable, remote
monitoring cannot be used.
[NET-
WORK
SET-
TING]
[TCP/IP] Settings [DISABLE] / [ENABLE]
Select the setting for connecting to
this machine through a network.
[IP
ADDR.
SET-
TING]
[IP ADDRESS] Type in the setting for [IP
ADDRESS].
The default setting is [0.0.0.0].
[SUBNET MASK] Type in the setting for [SUBNET
MASK].
The default setting is [0.0.0.0].
[GATEWAY] Type in the address for [GATEWAY].
The default setting is [0.0.0.0].
[DHCP] Settings [DISABLE] / [ENABLE]
If there is a DHCP server on the net-
work, specify whether the IP
address and other network informa-
tion is automatically assigned by
the DHCP server.
To Next Page
Loading...
