Dibal D900 Series - 3.9.3.6.Rounding Receipt; 3.9.3.7.Receipt Copy; 3.9.3.8.Receipt reopening

Maintenance Manual D900
49-MD900EN05
100
3.9.3.6.Rounding Receipt
This parameter is for activating or deactivating rounding off the total amount of the receipt. Rounding off is
performed on the total amount after any discount has been applied on the total (where applicable). The
following criteria are used:
Amounts that are multiples of 5 cents are left as such.
Other amounts are rounded off to the nearest multiple of 5 cents
3 lines will be shown:
Total (before rounding off)
Rounding off (up or down)
Rounded total
In the case of a secondary currency, only the total after rounding off will be given.
Possible values for this parameter are:
Enabled - Receipt with rounding
Disabled - Receipt without rounding
At the end of lists 7 and 9 a line is printed to indicate the total sum of rounding off that has been applied to
receipts.
E.x. TOTAL GR. ROUNDING OFF -0.02
3.9.3.7.Receipt Copy
The possible values are:
Enabled - It is possible to print receipt copies
Disabled - It is not possible to print receipt copies
The copies of receipt are printed with the text ****COPY****
3.9.3.8.Receipt reopening
The D-900 scales afford the possibility to select the REOPENING of receipt operating mode (see
paragraph 2.8.2.5. Receipt reopening).
‘0 - NO’ – Without reopening
‘1 - YES’ – Reopening of receipt, normal operation.
‘X – TIMED REOPENING’ – Timed reopening.
If the user sets a value other than ‘1’ or ‘0’, reopening is enabled for a specific length of time. Once this
time has passed the receipt can no longer be reopened.
Use the table below to configure the reopening time, depending on the ‘X’ parameter.
Parameter Reopening time
2 1 min.
3 1 min. 30 sec.
4 2 min.
5 2 min 30 sec.
6 3 min.
7 3 min. 30 sec.
8 4 min.
9 Without reopening time limit
Table 3-4