Maintenance Manual D900
49-MD900EN05
88
3.8.2.8.4 Label Opto Calibration
This menu allows to make an automatic calibration of the opto labels detector.
3.8.2.8.5 Allow Label Mode
This option allows to define the label working mode of the scale.
‘ALLOWED’ – It enables you to work in label mode. (Default value)
‘DISALLOWED’ – It does not enable you to work in label mode.
‘OBLIGATORY’ – It obliges you to work in label mode.
‘IT OBLIGES. WITH ACCUMULATION OF TOTALS PER ARTICLE’ – It obliges you to work in label
mode with accumulation of totals per article. The bar code on the totals label is the one selected in the
set-up menu for printing.
3.8.2.8.6 Adhesive Paper
With this parameter you decide on what kind of paper the cash register chit (register voucher) and the
label are to be printed. It is normally applicable to scales with two printers: The possible values are:
‘0 – CASH REGISTER CHIT AND LABEL ON SELF-ADHESIVE PAPER’
‘1 – CASH REGISTER CHIT ON FANFOLD PAPER, LABEL ON SELF-ADHESIVE PAPER’
‘2 – CASH REGISTER CHIT ON SELF-ADHESIVE PAPER, LABEL ON FANHOLD PAPER’
‘3 – CASH REGISTER CHIT AND LABEL ON FANHOLD PAPER’
3.8.2.8.7 Label Accumulation
This parameter is for determining whether the labels issued are accumulated.
‘NOT ACCUMULATE COPIES OF LABELS’ – Normal operation: each label is accumulated in sales
totals. Copies of labels cannot be accumulated in sales totals.
‘NOT ACCUMULATE LABELS NEITHER COPIES OF LABELS’ – All labels that are printed are NOT
accumulated in sales. If the client's number appears, it will show 0 and the receipt number will not
increase. Copies of labels cannot be accumulated in sales totals
‘ACCUMULATE LABELS AND COPIES OF LABELS’ – Normal operation: each label is accumulated
in sales totals. Copies of labels can be accumulated in sales totals.
3.8.2.8.8 Format for Total Label Level 1
The value of this parameter indicates the format with which the level 1 total labels are to be printed. If the
value is 0, the format of the labels that have been issued will be used.
3.8.2.8.9 Format for Total Label Level 2
The value of this parameter indicates the format with which the level 2 total labels are to be printed. If the
value is 0, the format of the labels that have been issued will be used.
3.8.2.8.10Format for Total Label Level 3
The value of this parameter indicates the format with which the level 3 total labels are to be printed. If the
value is 0, the format of the labels that have been issued will be used.
3.8.2.8.11 EAN Format Total Labels Level 1
Here, the EAN format of the level 1 totals label is selected if you wish to work with accumulated total
labels for an article (see paragraph 3.6.4.3.3 Levels deletion).
If this parameter is set to 0, the format of the labeled article will be printed (see paragraph 3.8.2.15 EAN
13 Label Format).
3.8.2.8.12 EAN Format Total Labels Level 2
Here, the EAN format of the level 2 totals label is selected.
If this parameter is set to 0, the format of the labeled article will be printed.
3.8.2.8.13 EAN Format Total Labels Level 3
Here, the EAN format of the level 3 totals label is selected.
To Next Page
Loading...
