OPERATOR’S MANUAL
OPERATIONAL TOTALS
Granular and liquid totals are logged individually and viewable on the Totals
screen by:
•
Current run totals
•
Season totals
•
Route
To view Operational Totals:
1.
At the (F12) Data Logging screen, press 5 to access the Operational
Totals menu screen.
2.
At the Operational Totals screen-Reset Totals Enable selection, select
Yes for operator access to clear totals from the Operate screen. Select
No for no operator access to clear totals. The Trip Log on the Totals
screen can be cleared with a Yes or No selection.
3.
Select the corresponding number key to view granular, liquid, anti-ice,
prewet, or active material totals. Active Materials screen displays and
clears only the current materials displayed on the Operate screen.
– Press More button to view additional materials.
4.
At the Material menu screen, select the corresponding number key to
view material totals.
5.
At the Totals screen, press C to clear current totals and S to clear
season totals.
Material totals are reported in tons, miles, and hours for current and season
totals for the following modes:
AUTOMATIC MODE- total miles driven is logged in miles (km), tons (metric/
English), and gallons (liters) for each control channel and product spread.
BLAST MODE- total miles driven in Blast mode is logged in miles (km), tons
(metric/English) and gallons (liters) spread for each product.
PAUSE MODE- total miles driven in Pause mode is logged in miles (km),
tons (metric/English), and gallons (liters) spread for each product.
Flex4 Pro
TM
Control System
6010541 Rev A
SYSTEM PROGRAMMING / 99
To Next Page
Loading...
