OPERATOR’S MANUAL
MAXIMUM MANUAL SPEED
Sets the maximum manual ground speed allowed to spread the target APR.
MANUAL SPEED
Represents the ground speed in miles per hour with an artificial,
internally-generated signal. Vehicle speed should run close to the
maximum manual speed to ensure materials are spread to the target APR.
CONTROL STARTUP SPEED
The speed the system begins to operate when ground speed sensor pulses
start. Until this threshold is crossed, the startup ground speed signal is
used.
CONTROL SHUTOFF SPEED
Minimum ground speed allowed before the system stops operation. It is
recommended that shutoff speed be set at 0.0 unless speed appears from a
mechanical sensor.
GROUND SPEED CONSTANT
Determines the number of pulses received from the ground speed sensor
per mile of travel. If unknown, the value automatically calculates during a
ground speed calibration.
Flex4 Pro
TM
Control System
6010541 Rev A
CALIBRATIONS / 117
To Next Page
Loading...
