Digi SM-720 - SIO Loop Back Test; RS485 Loop Back Test

SM720 Service Manual Edition 5
37
5.1.2.4 Printing Position
To adjust the printing position when printing is out of alignment. The process only allows adjusting vertical
position only.
KEY TO PRESS OPERATION
-- At R mode.
KEY TO PRESS OPERATION
+ [5][1][4]
-- Go to Thermal Head calibration.
THERMAL HEAD CALIBRATION
KEY TO PRESS OPERATION
[2][0]
OR
[2][0]
OR
-- Adjust upward.
-- Adjust downward.
-- Store new value and Exit to R mode.
0,000
0,000
0,00
0,00
OLD SETTING: 0
NEW SETTING: 0
0,000
0
,000
0,00
0,00