Digi SM-720 - User Specification Setup; IP Address Setting

SM720 Service Manual Edition 5
28
4.2 Touch Pole, Touch Bench and Touch Elevated Type
4.2.1 Default Country Spec Setting
Procedure Picture
1) Touch and hold the “Corner Side” of touch screen panel, then
switch power “ON” the scale.
Note: Ensure Span Switch is set in “On” position
2) Select Countries of scale and touch [Save].
3) Waiting until display shown [Memory Clear] and then touch [Yes]
to clear memory.
Note: If press [No] is not clear the memory.