Digi TransPort - Page 162

Configure Ethernet interfaces
Digi TransPort User Guide 162
eth n mhome 0-255 Multihome additional consecutive
addresses
eth n igmp 0,1 Enable IGMP on this interface
eth n bridge 0,1 Enable Bridge on this interface
eth n heartbeatip IP address Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
eth n hrtbeatint 0-86400 Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
This CLI value is entered in seconds
only.
eth n hbipent blank,ETH,PPP Use interface x,y for the source IP
address
x=Interface type
eth n hbipadd 0-255 Use interface x,y for the source IP
address
y=interface number
eth n hbroute 0,1 Select the transmit interface using the
routing table
eth n hbimsi 0,1 Include IMSI information in the
Heartbeat message
Entity Instance Parameter Values Equivalent Web Parameter