Digi TransPort - Page 188

Configure Wi-Fi interfaces
Digi TransPort User Guide 188
Rogue Scan parameters
In Rogue Scan mode, the router performs a scan of the Wi-Fi channels and will report what Wi-Fi
Access Points it detects. This feature can be used to detect unauthorised Access Points that might
be trying to get unsuspecting Wi-Fi clients to connect them.
When an authorized Access Point is detected, an event log entry is created and an alarm (such as
email, SMS, SNMP Trap) can be triggered.
It is possible to configure a list of the MAC addresses of the authorized Access Points that will not
be reported when detected.
MAC Address
The MAC address of an authorized Access Point.
Rogue Scan CLI Commands
WPA-PSK AES wifinode 0 security wpapsk
wifinode 0 wpatype aes
wifinode 0 sharedkey <8..63 char key>
WPA2-PSK AES wifinode 0 security wpa2psk
wifinode 0 wpatype aes
wifinode 0 sharedkey <8..63 char key>
Entity Instance Parameter Values Equivalent Web Parameter
macrogue n mac MAC address
with no
separators
such as
112233445566
MAC Address
Network
Authentication Data Encryption CLI Commands