Configure DSL interfaces
Digi TransPort User Guide 218
Stop data from being transmitted after
The maximum amount of data that may be transferred before the router locks the interface
and prevent further transfer. Along with the Issue a warning event after parameter, this
setting is used on networks where the tariff is based on the amount of data transferred to
help prevent excess charges being incurred. You can select kilobytes, megabytes or gigabytes
via the drop-down box.
Reset the data limit on the x day of the month
If you wish to automatically unlock a locked interface at the start of a new billing period, set
this parameter to the appropriate day of the month (from 1 to 28). When this date is reached
the router will unlock the interface and data transfer may resume. If the parameter is set to 0,
automatic unlocking will not occur and manual unlocking will be necessary (by clicking on the
Clear Total Data Transferred button on the appropriate Diagnostics-Statistics > PPP > PPP n
page. This parameter will also reset the statistics for the Data limit warning level (kb).
The factory default does not include any DSL settings and so when the router is first installed,
the following message appears:
This DSL PVC is not assigned to any PPP interface.
Click here to jump to the PPP Mapping page.
When clicked, this link will redirect the browser to the
Configuration > Network > interfaces > Advanced > PPP Mappings page. From this page,
select the desired PPP instance.
To Next Page
Loading...
