Digi TransPort - Page 261

Configure DialServ interfaces
Digi TransPort User Guide 261
Enable the firewall on this interface
When enabled, applies the firewall rules to traffic using this interface.
Related CLI Commands
Entity Instance Parameter Values Equivalent Web Parameter
ppp n name Up to 25
characters
Description
ppp n phonenum up to 25 digits Dial out using numbers
ppp n ph2 “ Dial out using numbers
ppp n ph3 “ Dial out using numbers
ppp n ph4 “ Dial out using numbers
ppp n prefix 0-9999999999 Prefix
ppp n username Up to 60
characters
Username
ppp n password Up to 40
characters
Password
ppp n IPaddr 0.0.0.0 Allow the remote device to assign a
local IP address to this router
ppp n IPaddr Valid IP address
a.b.c.d
Try to negotiate a.b.c.d as the local
IP address for this router
(in conjunction with l_addr)
ppp n l_addr OFF,ON
When ON,
allows
negotiation
when OFF force
use of specified
IP address
Use a.b.c.d as the local IP address
for this router (not negotiable)
ppp n DNSserver Valid IP address
a.b.c.d
Primary DNS server
ppp n secDNS Valid IP address
a.b.c.d
Secondary DNS server
ppp n IPmin Valid IP address
a.b.c.d
Assign remote IP addresses from
a.b.c.d to a.b.c.d
ppp n IPrange 0-255 Assign remote IP addresses from
a.b.c.d to a.b.c.d
ppp n transDNS Valid IP address
a.b.c.d
Primary DNS server a.b.c.d