Digi TransPort - Page 399

IPsec parameters
Digi TransPort User Guide 399
Renew the tunnel after
Defines the constraints of when the IPsec tunnel SA has to be renewed.
h hrs m mins s secs
Renew the IPsec SA after the specified amount of time.
n units of traffic
Renew the IPsec SA after the specified amount of traffic has been passed over the tunnel.
The units can be Kbytes, Mbytes or Gbytes.
A value of 0 means that this parameter is not used, and SAs will expire and be renewed based
time, rather than amount of traffic.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
eroute n descr String Description
eroute n peerip IP address or
hostname
The IP address or hostname of the
remote unit.
eroute n bakpeerip IP address or
hostname
Use n as a backup unit.
eroute n locip IP address IP Address (for Local LAN)
eroute n locmsk IP Mask IP Mask (for Local LAN)
eroute n locipifent blank, ETH, PPP Use interface x,y
x=Interface type
eroute n locipifadd Integer Use interface x,y
y=interface number
eroute n remip IP address IP Address (for Remote LAN).
eroute n remmsk IP Mask IP Mask (for Remote LAN).
eroute n remnetid String Remote Subnet ID.
eroute n authmeth Off, Preshared,
xauthinitpre, rsa,
xauthinitrsa
Use the following security on this
tunnel.
eroute n ourid String Our ID.
eroute n ouridtype 0=IKE ID
1=FQDN
2=User FQDN
3=IPv4 Address
Our ID type.
eroute n peerid String Remote ID.
eroute n privkey Filename RSA Key File.