IPsec parameters
Digi TransPort User Guide 404
remote TCP/UDP port n
Allow IP packets with matching destination TCP/UDP ports to be tunneled.
local TCP/UDP port in the range of n1 to n2
Allow IP packets with source TCP/UDP ports in the specified range to be tunneled. This is only
available when IKEv2 is used.
remote TCP/UDP port in the range of n1 to n2
Allow IP packets with destination TCP/UDP ports in the specified range to be tunneled. This is
only available when IKEv2 is used.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
eroute n mode tunnel,
transport
IPsec Mode.
eroute n ahauth off, md5, sha1 Use a AH authentication on this tunnel.
eroute n ipcompalg off, deflate Use c compression on this tunnel.
eroute n oosdelsa on, off Delete SAs when this tunnel is down.
eroute n ifvrrpmaster on, off Delete SAs when router is not a VRRP master.
eroute n nosaoos on, off Go out of service if automatic establishment
fails.
eroute n nosadeactcnt Integer Go out of service after n consecutive auto-
negotiation failures.
eroute n check_apnbu on, off This tunnel can only use apn.
eroute n apnbu 0=Main APN
1=Backup APN
This tunnel can only use apn.
eroute n ifent blank, ETH, PPP Link tunnel with interface with x,y.
x=Interface type
eroute n ifadd Integer Link tunnel with interface with x,y.
y=Interface number
eroute n inhibitno Comma
separated list of
Integers
Inhibit this IPsec tunnel when IPsec tunnels n are
up.
eroute n requireno Integer Inhibit this IPsec tunnel unless IPsec tunnel n is
up.
eroute n usesecip on, off IKE negotiation source IP address is taken from
the Secondary IP Address.
To Next Page
Loading...
