Digi TransPort - Page 405

IPsec parameters
Digi TransPort User Guide 405
eroute n ipent blank, ETH, PPP IKE negotiation source IP address is taken from
the Interface x,y.
x=Interface type
eroute n ipadd Integer IKE negotiation source IP address is taken from
the Interface x,y.
y=Interface number
eroute n intunnel on, off Tunnel this IPsec tunnel inside another IPsec
tunnel.
eroute n natkaint Integer NAT-Traversal Keepalive timer s seconds.
eroute n proto off, tcp, udp, gre Allow protocol IP protocol(s) in this tunnel.
eroute n toslist Comma
separated list of
Integers
IP packets with ToS values n must use this tunnel.
eroute n locport 0-65535 Only tunnel IP packets with local TCP/UDP port.
eroute n remport 0-65535 Only tunnel IP packets with remote TCP/UDP
port.
eroute n locfirstport 0-65535 Only tunnel IP packets with local TCP/UDP port in
the range of n1 to n2.
eroute n loclastport 0-65535 Only tunnel IP packets with local TCP/UDP port in
the range of n1 to n2.
eroute n remfirstport 0-65535 Only tunnel IP packets with remote TCP/UDP port
in the range of n1 to n2.
eroute n remlastport 0-65535 Only tunnel IP packets with remote TCP/UDP port
in the range of n1 to n2.
Entity Instance Parameter Values Equivalent Web Parameter