Digi TransPort - Page 507

Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort User Guide 507
snaip x tnoact 1000-60000 RR Timer.
snaip x t1time 1-60000 T1 timer.
snaip x t200 1-60000 T200 timer.
snaip x window 1-7 Window Size.
snaip x tinact 0-3000 Disconnect link if there has
been no activity for x seconds.
snaip x vmac Text (valid MAC
address)
Virtual MAC Address.
snaip x peervmac Text (valid MAC
address)
Virtual MAC Address of Peer.
snaip x IPaddr Text (valid IP address) IP address of the Peer DLSw
unit.
snaip x r_IPport 0-65535 Listen on Port.
snaip x w_IPport 0-65535 Use Port x if this unit starts
the DLSw protocol.
snaip X srcipent auto, eth, ppp Use interface for source IP
address.
snaip x srcipadd 0-255 Use interface for source IP
address.
snaip x sock_inact 0-2147483647 Close TCP connection if it is
idle for x secs.
snaip x ver 0-2 DLSw Ver.
snaip x passive 0= active,
1=passive
DLSw Role.
snaip x dlswwindow 1-100 DLSw Window.
snaip x udp_cap 1=enabled,
0=disabled
UDP Capable.
snaip x use1sock On, Off, Compatible Use 1 socket.
snaip x inc_mac_exc 1=enabled,
0=disabled
Include MAC Exclusivity
Capability.
snaip x mac_exc_val 0-1 Mac Exclusivity Value.
snaip x iunsolresp 1=enabled,
0=disabled
Ignore unsolicited response
frames.
snaip x waitforcontact 1=enabled,
0=disabled
Wait for Contact before
progressing to CONNECT
PENDING state.
Entity Instance Parameter Values Equivalent Web Parameter