Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort User Guide 508
Forcing SNAIP to use a specific instance
If several SNAIP instances share an ASY port, a switchover to a specific instance can be initiated by
issuing snasw x, where x is the SNAIP instance number. This instance must be available to go
online, or this command will fail.
To revert back and use the default instance, issue the snadis x command. Normal priorities are
used to determine which SNAIP instance gets to use the SYNC port.
snaip x con_attempts 0-2147483647 Make immediate connection
attempts before backing off
snaip x con_boff_time 0-2147483647 Backoff for x seconds before
attempting to connect again
Entity Instance Parameter Values Equivalent Web Parameter
To Next Page
Loading...
