Digi TransPort - Page 539

Configure X.25 parameters
Digi TransPort User Guide 539
Create an event when the following data is on the PAD
A string, which if it appears in the received data causes a Data Trigger (47) event to be
generated and recorded in the event log.
Create an event when there has been no activity on the PAD for x seconds
The time, in seconds, in which if there is no activity on the PAD an event in the event log is
posted. This can be used to trigger email exceptions.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
pad n l2iface lapb, lapd, TCP, SSL Use PAD over interface
pad n l2nb 0-255 (instance of LAPB
or LAPD)
Use PAD over interface
pad n ip_stream 0=off (for XoT), 1=TCP,
2=UDP
Use PAD over interface
pad n defpak 16,32,64,128,256,512 or
1024
Default X.25 packet size
pad n ansnua text (valid NUA) Answer incoming calls from
NUA
pad n anscug text (valid CUG) Only answer calls with CUG
pad n amacro text Use X.25 Call Macro
macroname to an ATD
command
pad n cingnua text (valid NUA) Use NUA
pad n lcn 1-4095 LCN
pad n lcnup 1=up, 0=down LCN Direction
pad n nuaimode 0=NUI and NUA, 1=NUA
only, 2=NUI only
NUI/NUA selection
pad n dorest 1=enabled, 0=disabled Enable X.25 Restart Packets
pad n restdel 0 -60000 (ms) Restart delay
pad n IPaddr text Remote IP address
pad n buipaddr text Remote IP Address when
using the backup interface
pad n ip_port 0-65535 IP Stream port
pad n iphdr 0=Off, 1=On, 2=8583
Ascii 4 byte
IP length header
pad n prompt text PAD prompt